Comtest-networks CPE-01V POTS Splitter Instrukcja Użytkownika Pobierz pdf

SA-2202-0016 Rev 3.0 1 of 2 June 1, 2011

Residential CPE-01V POTS Splitter Wall Installation Guide

Comtest Networks

Application

The CPE-01V splitter provides xDSL signal separation from the voice line within the customer’s residence, and can use

either single wires or RJ11 connectors. The CPE-01V also supports a secondary single-service line.

Preparation

The CPE-01V does not require an earth ground.

If using the IDC, only use 22AWG, 24AWG or 26AWG solid conductor wire. RJ11 wiring can be 22AWG, 24AWG or

26AWG stranded or solid.

Instructions

Mount the CPE-01V to a smooth surface, using a #4

or #6 Pan Head screw, suitable for the surface

material, no shorter than 3/8”. CPE-01V orientation

does not matter.

Pull each IDC towards you, until it swings open and

stops.

The CPE-01V has three connections:

 Modem – customer’s xDSL modem.

 Line – the incoming line.

 Phone - customer’s telephone

Each connection is shared between an RJ11 and IDC

connector. Each connection can accommodate only

one type of wiring.

If the IDC wire has been previously used, cut-off

approximately ½” from the end, before inserting into

the IDC connectors on the CPE-01V.

Mounting Hole

IDC

Incoming

Line

To xDSL

Modem

To Phone

RJ11

1 2

SA-2202-0016 Rev 3.0 2 of 2 June 1, 2011 If using the IDC: Carefully observe the proper orientation of the Tip-Ring leads. Do not remove the insula

Brak uwag

Comtest-networks CPE-01V POTS Splitter Instrukcja Użytkownika